New DVD Movies

This is a guide on how to wire additional monitors to a car DVD. When the vehicle is big, one monitor may not suffice the purpose and this is the main reason for installing multiple monitors in one car. There are different locations and one economically best location may be chosen to fix another monitor.

The monitors can be fixed if the location to be fixed is known and the following things are available: a measuring tape, pencil, paper, marker, knife, fasteners, scissors, and suitable adapter. The following are a sequential procedure of fixing numerous monitors to the same DVD player.

For knowing the size of the largest monitor that can be installed first use a tape measure to get the correct size of the head rest of the front seat. The head rest is removed and it is placed on a work bench or any other flat surface. This helps in a much safer and comfortable processing.

The cut out paper is then placed on the rear side of headrest and drawn again on the seat with a pen or pencil. An ‘X’ shape is marked on the seat. With the help of a knife, the shape of ‘X’ is cut out. This will make it easy to remove the padding. The padding is removed till the metal base is seen. The padding is properly removed so that the monitor fits in properly.

A hole that is small in size is cut out in the bottom of headrest. This will give enough room for the wires that are needed for connecting the DVD screens. The fasteners that are available are then placed with one end on the metal base and placed it back into the seat. The wires have to be connected by running it through headrest bars, seats and the floor. In the floor, the carpet can be cut open with tiny holes. The wires can then be run to the dashboard to the head unit of the Disc player.

After the foam is removed, one small hole is drilled in the bottom part of headrest. This will allow the wires to pass through that are necessary for connecting the monitor for DVD player. The fasteners are then placed in such a way that one end is on the metal base and then is set to position.

It is advisable to use pencils and not use permanent markers since it will not spoil the appearance of the seat. It is also essential not to start cutting headrest in the wrong spot which might lead permanent damage to the seat. The adapter may be used for additional connections.

Once the following steps are followed with small precautions of safety, the many monitors can be attached the same way. Hence this article on how to wire additional monitors to a car DVD can be useful.

Looking to find the best deal on Auto Hifi, then visit www.powernetshop.at to find the best advice on Car audio for you.